Skip to content

Le Beausset

L'actu de la région

Car Tips: How to Choose, Maintain and Get the Most Out of Your Car Every Day

A poorly maintained vehicle doesn’t always give you warning before it breaks down. The most expensive breakdowns stem from simple oversights, often…

Homme en train d'inspecter le moteur de sa voiture dans un garage, conseils d'entretien automobile au quotidien

A poorly maintained vehicle doesn’t always give you warning before it breaks down. The most expensive failures often stem from simple oversights, usually caused by not knowing the recommended inspection intervals or confusing manufacturer maintenance schedules with real-world needs. Choosing the right car also means anticipating the maintenance it will require based on your daily driving habits.

Manufacturer maintenance intervals and actual engine wear

Maintenance schedules in the owner’s manual are based on so-called “normal” driving conditions: a mix of journeys, steady speeds and a temperate climate. In practice, most drivers face severe conditions: frequent short trips, cold starts and heavy urban traffic.

In these conditions, engine oil degrades faster than the manufacturer’s recommended interval suggests. An engine that regularly makes trips of less than ten kilometres never reaches its optimal operating temperature. Condensation remains in the sump, diluting the lubricant and accelerating acidification.

We recommend halving the oil change interval for any vehicle used for urban driving on more than half of its trips. The oil filter should be replaced at every oil change, not every other one. The air filter should be visually inspected every six months in dusty areas or near construction sites.

The articles in Yann Savidan’s automotive section explain how to adjust maintenance schedules for different engine types, making it possible to tailor them to your own driving habits rather than a theoretical average.

Woman comparing two cars in a car showroom, a guide to choosing a new car

Tyres and pressure: mistakes that compromise safety

Even a tyre underinflated by a few tenths of a bar can increase braking distances and impair handling. Check tyre pressure when the tyres are cold, at least once a month. Refer to the label on the driver’s door jamb, not the tyre sidewall, which shows the maximum permissible pressure rather than the recommended pressure.

Tyre condition involves more than tread depth. Check the sidewalls for bulges, cracks or cuts. A tyre’s rubber hardens over time, reducing grip even if the tread wear indicator has not yet been reached.

Mountain law and winter equipment

Regulations require specific equipment from 1 November to 31 March in certain municipalities in mountainous areas. Each department concerned specifies which roads and municipalities are subject to the requirement. Being in a listed department does not mean that all its roads are covered.

Tyres bearing the 3PMSF marking (a snowflake and mountain symbol) meet the requirement. Tyres marked only M+S are no longer sufficient as the sole alternative following the end of the transition period. Penalties apply if you are stopped on a covered road without the required equipment.

Car battery and electrical system: diagnose problems before they cause a breakdown

The battery remains the leading cause of roadside assistance calls. Its capacity gradually declines, and a load test using a multimeter or dedicated battery tester can help you plan a replacement before it fails completely.

  • Cold voltage with the engine off: a reading well below the nominal range indicates that the battery is nearing the end of its life, even if the car still starts normally.
  • Corroded terminals: corrosion increases contact resistance and can cause intermittent voltage drops that are difficult to diagnose without cleaning the terminals first.
  • Parasitic drains: a dome light left on or an electronic module that fails to go into standby can drain a battery in a few days, especially in newer vehicles with numerous control units.

Testing the battery before each cold season prevents most starting problems. If a vehicle is parked for several days without being driven, a slow trickle charge helps preserve the cells’ chemistry.

Low-emission zones: check restrictions before you buy

Low-emission mobility zones (ZFE-m) are being introduced in French urban areas according to schedules set by each local authority. The boundaries, restricted Crit’Air categories and operating hours vary from one city to another.

Before buying, check which Crit’Air sticker the vehicle you’re considering can obtain and compare it with the restrictions currently in force or planned in the area where you usually drive. An older diesel may be a good deal in the countryside but could soon become unusable in a city centre.

Used electric cars: the trap of advertised range

On the used electric car market, the range quoted by the manufacturer does not reflect the battery’s actual capacity after several years of use. The traction battery’s state of health (SoH) can be measured with a dedicated diagnostic test. A degraded SoH reduces usable range and resale value.

Ademe notes that the price gap between electric and combustion-engine vehicles varies considerably by segment, while energy costs may be lower for electric cars. Comparing total cost of ownership means looking separately at the purchase price, charging costs based on your access to home or public charging, and reduced maintenance costs (no oil changes or clutch, and regenerative braking that reduces brake pad wear).

Couple loading groceries into their car boot, making the most of their car every day

Brake fluid and hydraulic system: an often-overlooked check

Brake fluid is hygroscopic: it absorbs moisture from the air over time. This water lowers the fluid’s boiling point. During prolonged braking (such as on a mountain pass or when driving with a heavy load), degraded fluid can cause vapour lock: bubbles form in the system, and the brake pedal sinks without resistance.

  • Brake fluid should be replaced according to the manufacturer’s recommendations, generally every two years, regardless of mileage.
  • The fluid’s colour provides a rough indication: dark or cloudy fluid has probably absorbed too much water.
  • Moisture content can be checked with a dedicated tester, available for just a few euros, which measures the fluid’s remaining boiling point.

This item is often missing from consumer checklists, even though it directly affects braking safety. A properly bled hydraulic system with fresh fluid ensures a firm, predictable pedal response on any type of road.

Vehicle maintenance is about more than following a list of mechanical tasks. It involves constantly balancing real-world use, local regulations and ownership costs. Drivers who adjust maintenance intervals to their journeys rather than relying on manufacturer averages reduce the risk of breakdowns and preserve their car’s value over the long term.

Car Tips: How to Choose, Maintain and Get the Most Out of Your Car Every Day